![background image](http://html.mh-extra.com/html/ge/zoneline-2500/zoneline-2500_use-and-care-manual_2198498006.webp)
Use This Problem Solver
PROBLEM
AIR
CONDITIONER
DOES
OPERATE
AIR CONDITIONER
“DOES
COOL
OR HEAT AS IT
SHOULD”
“BURNING” ODOR
AT
OF
HEATING
OPERATION
SOUNDS
DISCHARGED AIR
CONDENSES ON
WINDOWS OR
WALLS
POSSIBLE CAUSE AND
REMEDY
Power cord
plugged
fuse blown, or circuit breaker tripped.
Power Switch behind room cabinet is set at OFF.
●
Unit is waiting 3 minutes for pressure to equalize across the compressor.
Curtains, blinds or furniture blocking front of air conditioner will restrict air flow.
●
Thermostat Control may not be set high enough. Slide control to a lower or higher
Highest setting
provide maximum cooling.
Air
dirty,
be cleaned
least every 30 days. See instructions
page 5.
*
Room may have been very
or very cold when air conditioner was first turned on.
time for it to cool down or warm up.
air maybe escaping through open furnace
floor registers and cold air
returns.
Ventilation
allowing
outside air to
the room.
The
other than normal.
This
limit the operating ranges, See page 4.
●
Position of the louvers
affect temperature. Seepage
Dust accumulating
surface of heating element during transportation or storage
can cause “burning” odor at beginning of heating operation. This odor should
dissipate.
●
Relay clicks may be
when compressor or fan cycles on and off. This is normal.
Fan
continuously when Thermostat Switch is set at FAN ONLY or Fan Cycle
Switch
room cabinet is set at CONTINUOUS. This is normal. Otherwise, the
cycles on and off with the compressor or resistance heater,
●
Tilt louvers down slightly and keep them down until condensation disappears.
If
need more
call. toll free:
GE Answer Center”” ‘
consumer information service
6