GE WW3000S, Use And Care Manual, Page: 5 / 20

Wash Water Temperature Selection
For hot water wash, set Cycle Selector
RINSE WATER TEMPERATURE WILL
to WASH. ALWAYS BE COLD.
●
For cold water wash, set Selector
to COLD WASH.
Starting or Choosing the Cycle
●
Pull Cycle Selector knob out to start the cycle.
START ,
If you wish to change cycle setting after washer has
started, push Cycle Selector knob in to stop washer
/ ‘
and reset to the new position. Setting can be changed
at any time during the cycle.
STOP
How to Soak in Your Washer
Allow the washer to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob to stop the washer
(keep lid closed) and allow to soak for as long as desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
Cycle Times — Total Cycle Times (Approximate Minutes)
NOTES:
Total time includes pauses between each phase of the cycle.
●
Total time does include water fill times. Fill times vary
depending on household water pressure and your selected water level.
ENERGY-SAVING
If clothes and household items don’t look clean
●
rinse in cold water. The
and fresh after washing, you will probably rewash
.
of the rinse does not affect cleaning.
them.. and that means you’ll waste energy.
Remember to sort your clothes carefully, and load
●
Wash in off-peak utility hours. Your local utility
them properly, select correct cycles, use enough
can tell you which are the off-peak hours.
detergent and choose water temperature warm ●
Use your washer’s Normal Spin. This will remove
enough to release and get rid of soil.
more water during spin, which will shorten drying
●
to wash less often. Save articles of the same
cycle to save more energy.
type of fabric until you have a full load.
5