GE Vivid S5 N, Service Manual

Page: 668 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
8-142 Section 8-6 - Lower Section Components Replacement Procedures
P R E L I M I N A R Y
8-6-6 ECG Module Assembly Replacement Procedure
(cont’d)
When disconnecting the cable, it is necessary to press the cable connector latch down ( Figure 8-173 ):
8) Remove the ECG Module Assembly from the system - see Figure 8-174 on page 8-142 .
8-6-6-5 ECG Module Assembly Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the
8-6-6-4 "ECG Module Assembly Removal Procedure" on page 8-140 .
1) Return a new ECG Module assembly (and attached fastening bracket) to the cabinet cage
assembly and lay it upside down (on top of the battery), as shown in Figure 8-173 on page 8-142 .
2) Re-connect the ECG cable (seen in Figure 8-176 ) to the ECG Module assembly (push it until it
clicks into position).
3) Re-connect the USB cable to the ECG Module assembly - seen in Figure 8-176 .
Figure 8-173 Disconnecting the ECG Cable
Figure 8-174 ECG Module Assembly Removed
ECG Cable
Connector Latch