(continued)
Rollers
Adjustable rollers behind the base grille enable you to
When adjusting front rollers
move the refrigerator away from the wall for cleaning.
for proper door closure, we
These rollers should be set so the refrigerator rests
recommend that the bottom
on the floor. To assure that the doors will close
front edge of the cabinet be
automatically from a halfway-open position, there is a
approximately 5/8” from the
built-in tilt from the front to the back of the cabinet.
floor.
Side-by-side refrigerators also have specially designed
door hinges that lift both doors slightly when opened,
allowing the force of gravity to help close them securely.
screws clockwise to raise
To adjust rollers, remove
the base grille by grasping
it at the bottom and pulling
Turn roller
,
refrigerator, counterclockwise to lower it. Use
adjustable wrench (3/8” hex head bolt) or pliers.
To replace base
grille, align prongs
on back of grille
with clamps in
cabinet and push
forward until grille
snaps into place.
Water Supply to
You will need to connect your
to a cold water line. A water supply kit containing copper
tubing, shut-off valve, fittings and instructions is available at extra cost from your dealer. There
should be sufficient tubing for the
from the cold water supply to allow you to move the
refrigerator out from the wall several feet (approximately 8 feet of 1/4” copper tubing in three
10-inch diameter coils.)
14
