The water and ice dispenser spill shelf should be
wiped dry immediately to prevent spotting. Water left on
the shelf may leave deposits that you can remove by
soaking with undiluted vinegar. You can also use a paste
of non-precipitating water softener (such
as
brand) and water, or one teaspoon of citric acid powder
per pint of hot tap water. Soak until the deposit
disappears or becomes loose enough to rinse away.
Usually minutes soaking time is adequate. Avoid
using wax on the spill shelf and trim.
The door handles and trim can be cleaned with a cloth
dampened with a solution of mild liquid dishwashing
detergent and water. Dry with a soft cloth. ‘
Cleaning—Inside
Inside the fresh food and freezer compartments should
be cleaned at least once a year. Unplug the refrigerator
before cleaning. this is not practical, wring excess
moisture out of sponge or cloth when cleaning around
—.
switches, lights or controls.
Use warm water and baking soda solution—about a
tablespoon of baking soda to a quart of water. This both
cleans and neutralizes odors. Rinse thoroughly with water
and wipe dry.
Other parts of the refrigerator—including door gaskets,
meat and vegetable drawers, ice storage bin and all plastic
be cleaned the same way. After cleaning door
gaskets, apply a thin layer of petroleum jelly to the door
gaskets at the hinge side. This helps keep the gaskets from
sticking and bending out of shape. If the freezer baskets
don’t slide freely after cleaning, lubricate them with
petroleum jelly. Do not use cleansing powders or other
abrasive cleaners.
Keep the finish clean. Wipe with a clean cloth lightly
dampened with kitchen appliance
or mild liquid
dishwashing detergent. Dry and polish with a clean, soft
cloth. Do not wipe the refrigerator with a soiled dishwashing
cloth or wet towel. These may leave a residue that can erode
the paint.
Do not use scouring pads, powdered cleaners,
bleach or cleaners containing bleach because these products
can scratch and weaken the paint finish.
Protect the paint finish.
finish on the outside of the
refrigerator is a high quality, baked-on paint finish. With
proper care, it will stay new-looking and rust-free for
years. Apply a coat of
when the
refrigerator is new and then at least twice a
Appliance Polish Wax & Cleaner (Cat. No.
is available from GE Service and Parts Centers.
To help prevent odors, leave an open box of baking soda in
the rear of the refrigerator, on the top shelf. Change the box
every three months. An open box of baking soda in the
freezer will absorb stale freezer odors.
Do not wash any plastic parts from your
refrigerator in your automatic dishwasher.
Drain opening in freezer compartment. During yearly
cleaning, remove bottom freezer basket and flush a solution of
baking
teaspoon and two cups
of hot (not boiling) water— through the
drain line with the help of a meat baster.
This will help eliminate odor and reduce
the likelihood of a clogged drain line.
If drain becomes clogged, use a meat
baster and baking-soda-and- water
solution to force the clog through the drain line.
Behind Refrigerator
Care should be taken in moving your refrigerator away
from the wall. All types of floor coverings can be
damaged, particularly cushioned coverings and those
with embossed surfaces. Pull the refrigerator straight
out and return it to position by pushing it straight in.
Moving your refrigerator in a side direction may result
in damage to your floor covering or refrigerator.
Condenser
condenser is located behind
the base grille. For most efficient
operation, remove the base grille
and either sweep away or
vacuum up dust that is readily
accessible. For best results, use a
brush specially designed for this
purpose. It is available at most
appliance parts stores. This easy
cleaning operation should be done at least once a year.
(continued next
11
