GE SpeedCook PSB9240DF, Installation Instructions Manual

Page: 9 / 32

9
Installation Preparation
Preparation
WITH
an Accessory Storage Drawer
NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE
INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING
(CONT.)
Installation over a GE/Monogram Oven
and Warming Drawer:
* For existing cutouts, a maximum width of
28-1/2” is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location do
not obstruct the required interior depth and height.
See Warming Drawer installation instructions for
details.
CAUTION
For personal safety, the
mounting surface must be capable of supporting
the cabinet load, in addition to the added
weight of this approximate 80-pound oven and
30-pound drawer, plus additional oven loads of
up to 50 pounds or a total weight of 160 pounds.
PRECAUCIÓN
Para seguridad personal,
la superficie de montaje debe poder soportar
la carga del gabinete, además del peso
aproximado de 80 libras del horno y las 30
libras del cajón, más las cargas adicionales
del horno de hasta 50 libras o un peso total de
hasta 160 libras.
Construct
Solid Bottom
Min. 3/8”
Plywood
Supported
by
2x4 or 2x2
Runners all
Four Sides
30”
23-1/2”
21”
2” Min.
Per Oven
Requirement
45-1/4”
Min.
PREPARE THE OPENING
(CONT.)
Installation over a GE/Monogram Oven:
* For existing cutouts, a maximum width of
28-1/2” is acceptable. If the opening is slightly
wider, secure a furring strip on each side of the
cutout for securing the oven.
• If you are replacing a GE/Monogram electric
double oven with the combined installation of
an Advantium 240V and a single oven, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2” minimum shown.
30”
23-1/2”
25-1/4”
Min.*
21”
45-1/4”
Min.
Construct
Solid Bottom
Min. 3/8”
Plywood
Supported by
2x4 or 2x2
Runners all
Four Sides
Per Oven
Requirement
2” Min.
(3” recommended)
2” Min.
(3” recommended)
Per warming drawer requirement