Installation Instr
uctions
Operating Instr
uctions
Troubleshooting Tips
Consumer S
uppor
t
Safety Instr
uctions
www.GEAppliances.ca
33
6
7
8
REASSEMBLE DOOR ASSEMBLY
MOVE STRIKE BRACKET
REINSTALL DOOR ASSEMBLY
IMPORTANT:
Make sure there is no dirt or any other
foreign material in between the window panes.
Place the plastic cover onto the inner door and lock in
place with the 4 tabs.
Place the outer door onto the inner door.
After reversing door, there will be a mismatch between the
outer door and the inner door.
Make sure that the
handle part of the
outer door is
opposite the
hinge, as shown.
Turn the door over and
fasten the outer door to
the inner door using the
6 large tapping screws
(#10).
Top of Door
Outer
Door
Inner
Door
Using a putty knife or any other flat tool, remove the 5
plastic screw caps located on the dryer where the door
will be installed and install them on the opposite side.
Switch the strike bracket and its cover on the opposite
side by removing the screws; then reinstall both on the
opposite side.
The door is now ready to be installed on the dryer. To
ease this step, the hinge has keyholes that allow a
partially fastened screw to be used as a hook.
Partially fasten a screw to the uppermost screw hole.
Hook the door on the partially fastened screw.
Fasten the hinge by installing the other 4 screws and
tightening the partially fastened screw above.
Partially
Inserted Screw
Tighten All
Screws