Installation Instr
uctions
Operating Instr
uctions
Troubleshooting Tips
Consumer S
uppor
t
Safety Instr
uctions
www.GEAppliances.ca
31
2
3
REMOVE DOOR ASSEMBLY
(cont.)
REMOVE HINGE
Lay the door down on a soft protected flat surface so that
the inner part faces upward (door resting on the handle
side).
Remove the 6 large tapping screws (#10) located around
the perimeter of the door outlining the gasket, and the 2
machine screws (#8) on the hinge side.
With the screws removed, turn the door over and
separate the silver cover part of the door from the door
frame and set aside.
Unlock the 4 tabs on the plastic cover and separate the
plastic cover from the frame.
NOTE:
Disregard the “DO NOT REMOVE” label on the
plastic cover.
IMPORTANT:
Note the location of the hinge (left or right)
before removing.
With the door frame part of the door laid down on
a protected soft surface, remove the hinge cover by
removing the 2 tapping screws (#8) that fasten it to the
frame. The hinge cover is located at the opposite side of
the hinge assembly.
Remove the 2 nuts, washers and the 2 machine screws (#8).
Remove the hinge assembly by removing the 2 machine
screws (#8) that fasten it to the frame. Pull the hinge
assembly out and set it aside.
6 #10 Large
Screws
2 #8 Machine
Screws
2 #8 Machine
Screws