14
49-85215-2
USING THE O
VEN:
O
ven Contr
ols
Oven Controls
To operate the oven:
1.
Ensure gas is available at the range by lighting any
surface burner and turning it off again.
2.
Push and turn knob to the
PILOT
position.
3.
Push in completely and hold for 10 seconds, then
release (Holding in on the oven control knob for less
than 10 seconds at the
PILOT
position may cause
the oven burner not to light).
4.
Push and turn to the temperature you want.
5.
Check for oven burner flame by opening the oven
door and looking through the hole at the front of the
oven bottom.
If no sparking noise is heard when the oven
temperature knob is pushed in at the
PILOT
position,
replace the battery with a fresh 9V alkaline battery.
Battery compartment is located behind the broil door.
6.
Turn the control knob to
Off
when finished baking.
To Adjust the Thermostat (on models with an OVEN TEMP Knob)
1. Pull
the
Oven Temp
knob off the range and look
at the back side. To make an adjustment, loosen
(approximately one turn), but do not completely
remove, the two screws on the back of the knob.
2.
With the back of the knob facing you, hold the outer
edge of the knob with one hand and turn the front of
the knob with the other hand.
To increase the oven temperature, move the top
screw toward the right. You’ll hear a click for each
notch you move the knob.
To decrease the oven temperature, move the top
screw toward the left.
Each click will change the oven temperature
approximately 10°F. (Range is plus or minus
60°F from the arrow.) We suggest that you make
the adjustment one click from the original setting
and check oven performance before making any
additional adjustments.
3.
After the adjustment is made, retighten screws so
they are snug, but be careful not to overtighten.
4.
Replace the knob, matching the flat area of the
knob to the shaft, and check performance.
Lighting the Oven with a Match
The oven of a battery-powered cordless range may be lit
with a match and operated normally, even if the battery
is too weak to activate the spark system. Follow these
steps to match-light the oven burner:
1.
Remove the oven door, oven racks, and oven
bottom. To remove oven bottom, remove two 1/4”
hex head screws at the rear of the oven.
2.
Locate the oven burner pilot at the left rear of the
oven burner.
3.
Hold a lit match to the oven burner pilot. Turn the
oven control knob to the
PILOT
position and push in
completely.
4.
After pilot lights, continue to hold in firmly on the
knob for 10 seconds before releasing.
5.
Pilot should remain lit. If not, repeat steps 3 and 4.
6.
Replace oven bottom, racks, and oven door.
7.
Turn knob to the desired temperature setting. Oven
will operate normally.
Turn oven control knob to
Off
when finished baking.
LOOSEN S
CRE
W
S T
O R
OT
AT
E
MA
KE
CO
OLE
R
MA
KE
HO
TTE
R
Back of OVEN TEMP knob
(knob appearance may vary)
PIL
OT
