GE Profile WPRB9250, Technical Service Manual

Page: 46 / 49

– 44 –
WATER Possible Causes What To Do
Too many suds
Type of detergent
•
Switch to a lower sudsing detergent brand and follow
instructions on package.
Very soft water
•
Try less detergent.
Too much detergent
• Measure your detergent carefully. Use less soap if you
have soft water, a smaller load or a lightly soiled load.
Water leaks Fill hoses or drain hose is • Make sure hose connections are tight at faucets
improperly connected and at washer.
• Make sure end of drain hose is properly connected
to washer and correctly inserted in and secured to
drain facility.
Household drain may
•
Check household plumbing. You may need to call a
be clogged plumber.
Constant water pressure
•
Tighten hoses at the faucets and turn the water off after
to the fill hoses at the each use.
water source
•
Check condition of the fill hoses; they should be
replaced every 5 years.
Using too much detergent
•
Use less detergent. Use less soap if you have soft water,
in washer a smaller load or a lightly soiled load.
Water temperature
Control is not set properly
•
Check water temperature control and adjust.
is incorrect
Water supply is turned off
•
Turn both hot and cold faucets fully on and make sure
or improperly connected hoses are connected to correct faucets.
Water valve screens are
•
Turn off the water source and disconnect water fill
stopped up hoses from the upper back of the washer. Use a brush or
toothpick to clean the screens in the machine. Reconnect
the hoses and turn the water back on.
House water heater is
•
Make sure house water heater is delivering water
not set properly at 120°F–140°F (48°C–60°C).
PerfecTemp Plus
feature
•
The lid must be closed for
PerfecTemp Plus
to work.
was not activated
Water pumped out
Lid lifted or cycle was put in
•
Reset cycle.
before cycle is
pause for over 24 hours
complete
Water won’t drain
Drain hose is kinked or
•
Straighten drain hose and make sure washer is not sitting
improperly connected
on it.
•
Top of drain outlet should be less than 8 ft (2.5 m)
above floor.
Water spraying during
Washer in spin cycle
•
Spray rinse during a spin cycle is normal.
spin cycle
Washer did not fill
Extremely low water pressure
•
Press the START button again.
Inlet hoses are kinked
•
Straighten hoses.
Water valve screens are • Turn off the water source and disconnect water fill
stopped up hoses from the upper back of the washer. Use a brush or
toothpick to clean the screens in the machine. Reconnect
the hoses and turn the water back on.
Water fills and drains Drain stand pipe is too low • Drain stand pipe must be above 30
″
(76.2 cm).
at the same time
to chosen level