49-3000206 Rev 3
7
A
B
C
Power
Press to “wake up” the display. If the display is active, press to put the dryer into idle mode.
NOTE:
Pressing
Power
does not disconnect the appliance from the power supply.
Start and Pause
Press
Start
to begin the cycle.
NOTE:
The door must be closed for the dryer to start the cycle. Pressing
Start
again will pause the cycle, the
Start
light may blink and “
Pause
” will display.
To continue the cycle, press
Start
again.
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle. On some models, the dryer cycle
status (
Sense
,
Drying
,
Damp
and
Cool
) will be shown.
In addition, the display will show:
USING THE DR
YER
Getting started
(WiFi)
(on some models)
Will allow your appliance to communicate with your smartphone for remote appliance
monitoring control and notifications.
Controls
The dryer is locked - will blink once if you press any pad or turn the cycle knob.
Check Filter
The
Check Filter
light will stay on for 15 seconds after the cycle stops.
Check Vent
The
Check Vent
light indicates an issue has been found due to reduced airflow from a possible
blocked or restricted vent. Checking and/or cleaning the vent system is recommended. See the,
“Check Vent” light is on
in the
Troubleshooting Tips
section.
(on some models)
Your dryer is equipped with
Artificial Intelligence
capabilities. This indicator will illuminate when
Washer Link
is active,
My Settings
are being implemented based on your usage habits and
suggested actions are available through the
SmartHQ
app.
Summary of Contents for PFD95
Page 125: ...49 3000206 Rev 3 41 Notas NOTAS...
Page 126: ...42 49 3000206 Rev 3 NOTAS Notas...
