GE NetworX NX-148E-CF, User Manual

Page: 8 / 32

NX-148E-CF
6
UNDERSTANDING THE LIGHTS
Armed Light The armed light is “on” when the system is armed. The armed
light is “off” when it is disarmed. The armed light will flash
when there has been an alarm during the previous arm cycle.
Bypass Light The
bypass light is “on” when any zone in this keypad’s
partition is bypassed. If the bypass light is “off”, no zones are
bypassed.
Cancel Light The
cancel light will flash during an abort delay time. Entering
a code followed by the [CANCEL] key during or after an
alarm report to the central station will cause the cancel light
to come on. It will stay on until the central station has
received the cancel report. NOTE: The cancel feature must
be enabled. (See "Cancel/Abort Feature" on page 10.)
Chime Light The
chime light is “on” when the chime feature is “on”; “off”
otherwise.
Exit Light The
exit light is “on” during the exit delay. Please note that the
light will flash during the last 10 seconds of the exit delay as a
warning that the time is running out. (The user may want to
disarm the system if the exit light is flashing in order to
prevent an alarm. The user may then re-arm the system and
exit before the delay expires.)
Fire Light A
steady fire light means a fire zone has been faulted. A
rapidly flashing fire light means that a fire zone is in a trouble
condition.
Power Light The
power light is on if the primary power is on. The power
light will flash if the system has a low battery condition.
Ready Light The
ready light is “on” when the system is ready to arm and
“flashes” if ready to force arm. The ready light is “off” when
the system is not ready to arm because of a zone(s) being
faulted.
Stay Light The
stay light is illuminated when all interior zones are
bypassed.
Instant Message The LCD display will read “Instant“ when the entry/exit door(s)
have no delay. (See “Arming System in Stay Mode”, page 8.)
The doors can be changed from instant to delay (toggled) by
pressing the [STAY] key when the system is armed.