GE MP100 Series, Service Manual

Page: 103 / 314

Configuration
2026419-033E CIC Pro™ 6-9

Configure the printer settings on page 6-36 .

Set the CIC Defaults on page 6-36 .

Set the Telemetry Unit Defaults on page 6-44 .

Set the Telemetry Alarm Control Defaults on page 6-45 .

Set the full disclosure defaults on page 6-47 .

Set the Display Configuration (non-mirror CIC Pro centers) on page 6-49 .

Set the Current Telemetry Listings on page 6-51 .

Check and configure the speaker volume on page 7-5 .

Set up locked beds on page 6-53 .

Configure customize groupings on page 6-61 .

Set up customize groupings for graphic trends on page 6-61 .

Set up custom groupings for vital signs on page 6-64 .

(Chinese only) Set the pressures unit-of-measure on page 6-53 .

Screen calibration on page 6-55 .

Define the Internet options on page 6-58 .

Configure shortcuts to favorite CIC Pro center views on page 6-65 .

Configure the print location settings for stored patient data on page 6-67 .

Set the time-of-day or the date on page 6-68 .

Back up and restore the CIC Pro center configuration on page 6-71 .
Reconnect the CIC Pro center with the network

Connect the CIC Pro center to CARESCAPE Network IX and MC networks.

Verify network and time settings. For instructions on running the Check Centrals
utility, see
Pre-configuration instructions on page 6-2 .
Perform MultiKM (Multimouse) setup

Pre-configure the CIC Pro centers on page 6-78 .

Configure the keyboard and mouse group on page 6-80 .

Change a keyboard and mouse group on page 6-83 .
Run Log File Compression Configuration Utility
This utility must be run:

After upgrading to CIC Pro center software v5.1.x
 When a CIC Pro center v5.1.x is added to an existing Multimouse group

Initial configuration of any CIC Pro center v5.1 device during new installs