Dual Range Top Burners
Outdoor Range Top Burners
8
General
information
Your range top burners are equipped with heavy
cast iron burners. They are rated at 15,000 BTU
and have a spark igniter knob for efficient
lighting.
The range top burners come with a stainless
steel cover. On cart-mounted units, the stainless
steel cover doubles as a work surface. When using
the grill burners with the work surface in place,
be careful as heat can conduct from the grill
section and cause the work surface to heat up.
Never attempt to light the range top burners
with the work surface in place.
Cover the range top burners with the stainless
steel cover when not in use.
IG
NI
TO
R
RE
AR
FR
ON
T
To light a
range top
burner
First remove the burner cover, by lifting up and
to the side, or any cooking utensils from the
burner grate.
CAUTION:
On cart-mounted units, the burner
cover may be hot if the grill burners are in
operation.
Push and turn the control knob to the LITE
position and immediately turn the igniter knob
until the burner is lit or 4 seconds pass. It may
be necessary to turn the igniter knob several
times until the gas has filled the line.
If the burner doesn’t ignite, wait 5 minutes for
any accumulated gas to dissipate, then try again.
If the burner will not light after several attempts,
wait 5 minutes. The burner can be lit by holding
a lit match next to the burner ports and turning
the control knob to LITE.
Move your hand immediately once the burner is
lit. Turn the control knob to the desired setting.
Flame
height
The correct height of the flame depends on
the size and material of the pan being used, the
food being cooked and how much liquid is in
the pan.
• The flame should never extend beyond the
bottom of the pan.
• Pans that conduct heat slowly (such as glass-
ceramic) should be used with low or medium
flame unless you are cooking with a large
amount of liquid.
Note:
The flame size on a gas burner should match
the cookware you are using.
Correct
Incorrect
Control knobs
Spark igniter knob
The burner grate is porcelain enamel
over cast iron for durability.
If the burner will not light you can use a match.
