7
Installation
Warming Drawer
Step 1
Install
Anti-Tip
Brackets
Provide
Cabinet
Support
IMPORTANT:
When installed below a single or double oven,
check to be sure that any oven supports above the cutout do not
obstruct the 23-1/2” required depth of the warming drawer cutout.
• A 2" min. clearance between oven and
warming drawer cutouts are required.
Additional clearance may be required if
2 x 4 blocks are used to support runners or
solid floor of the oven above.
• The warmer drawer may be supported by
either a solid bottom, 2 x 4 or 2 x 2 runners.
• The support must be level and rigidly
mounted, flush with the bottom edge of
the cutout.
– There is no way to level the drawer once
it has been installed. Be sure supports are
level.
• The entire weight of the drawer is supported
by the runners or solid floor and must be
capable of supporting 150 lbs.
Step 2
Install
Warming
Drawer
• Slide left corner of the drawer into the
opening.
• Push power cord into the hole leading to
the outlet location. Thread the cord through
as drawer is being pushed back into the
opening. Check to be sure power cord does
not get trapped under the drawer.
– If the outlet is installed inside the
opening, plug the cord into the outlet.
In this location, the excess power cord
length should be coiled and taped to
the right side of the unit.
• Push the drawer back until the front flange
is flush to the cabinet front.
• Open the drawer fully.
• Drill pilot holes through the holes in the
overlaping frame, one on each corner.
• Drive wood screws provided into each corner.
23-1/2"
22"
27"
2"x 4" or
Equivalent Runners
23-1/2"
25"
30"
2"x 4" or
Equivalent Runners
9"
2x4 or 2x2
Runners or Solid
Bottom
Install
2x4 or 2x2
Anti-Tip Block
Against Rear
Cabinet Wall
9" From Floor
to Bottom
of Block
WARNING:
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent
the drawer from tipping forward when
opened and loaded. Failure to do so could
result in personal injury.
PRÉCAUTIONS :
CONTRE LE BASCULEMENT
Pour éviter les blessures, il faut installer une
patte de retenue pour empêcher le tiroir de
basculer quand il est ouvert et plein.
