– 10 –
Locator Pin
Electrode
Burner Ring
Locking Nut
With Chamfer
Side View
Burner Base
Burner Head
(Brass)
Locator Pins
Burner Ring
(Aluminum)
Burner Cap
Pin Slot
Note: Locator Pin Fits
Into Burner Base Pin Slot
Oven Light Bulbs
Bulb
Socket
Tab
Glass cover
Receptacle
Caution:
Before replacing the oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel.
Note:
Allow light cover and bulb to cool
completely.
Replace with a new 130V halogen bulb, not to
exceed 35 watts.
To remove and replace the oven light bulb:
1. Turn the glass cover counterclockwise
1
/
4
turn
until the tabs of the glass cover clear the
grooves of the socket.
2. Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
3. Using gloves or a dry cloth, remove the new
bulb from its packaging.
Do not touch the
bulb with bare fingers.
4. Push the bulb straight into the receptacle all
the way. Place the tabs of the glass cover into
the grooves of the socket. Turn the glass
cover clockwise
1
/
4
turn to engage.
5. For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is
completely cool.
6. Reconnect electrical power to the oven.
Surface Burner
To remove the surface burner:
1. Lift off the burner cap and burner head.
2. Remove the burner ring locking nut using a
1
1
/
16
-in. socket wrench, crescent wrench or
channel-lock pliers.
3. Lift off the burner ring.
Do not remove the
burner base.
To replace the surface burner:
1. Align the locator pins on the burner ring into
the labeled hole in the burnerbase. Seat in
place and push toward the electrode to set
gap properly.
2. Replace the burner ring locking nut. Tighten
the nut three times to remove small
imperfections in the parts. This will ensure the
nut remains tight over life:
•
Hand tighten nut, tighten
1
/
4
turn with
wrench or pliers, then loosen.
•
Hand tighten nut a second time, tighten
1
/
4
turn with wrench or pliers, then loosen.
•
Hand tighten nut and final tighten
1
/
4
turn
with wrench or pliers.
3. Align the locator pin in the burner head into the
hole in the burner ring. Seat in place.
4. Replace the burner caps.
Summary of Contents for Monogram ZDP30_ _H
