– 21 –
Electronic Control Housing Components
Note:
The control housing components consist of:
Electronic control board
•
Dual transformer
•
Light switch
•
Push-button switch assembly
•
Remove the cutter grid cover and the cutter
1.
grid. (See
Cutter Grid
.)
Disconnect the 2 thermistor connectors. (See
2.
Bin
Thermistor
and
Evaporator Thermistor.
)
Remove the 4 hex-head screws from the control
3.
housing and lower the housing to access the
components.
To Remove the Electronic Control Board
Disconnect the 6 harness connectors from the
1.
board terminals.
Remove the 2 mounting screws and remove the
2.
electronic control board.
To Remove the Dual Transformer
Disconnect the 6-pin wire connector from the
1.
harness.
Remove the 2 mounting screws from the
2.
transformer bracket.
Disconnect the green ground wire from its
3.
terminal.
To Remove the Light Switch/Push-Button
Assembly
Note:
If the switch assembly or light switch is
replaced, the replacement part and decorative
overlay must be ordered using the model number of
the icemaker. The service replacement switch is not
supplied with a decorative overlay
Peel off the decorative overlay from the front of
1.
the control housing.
Transformer
2nd screw on opposite side
(Continued next page)
