5
STEP 2 LEVEL
• Use an adjustable wrench to turn the leveling legs and
raise or lower the product.
• Adjust carefully; the product should be level and plumb
with cabinetry, and should align with adjacent toekick
height.
STEP 4 SLIDE PRODUCT INTO
THE CUTOUT
WARNING:
Do not apply pressure or push
against the glass door when moving or installing these
products. Pressure against the glass door will cause
damage.
AVERTISSEMENT :
Ne poussez
jamais et ne mettez jamais de pression sur la porte
en verre quand vous déplacez ou installez ces produits.
Toute pression sur le verre occasionnera des
dommages.
• Carefully slide the unit into the opening. Be careful
not to entangle power cord.
• Make certain that the door protrudes 1
″
beyond
the surrounding cabinets.
• Check again to be sure the unit is level.
STEP 3 CONNECT POWER
• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
STEP 5 CHANGE THE TOEKICK
• The stainless steel toekick is secured to the back
of the product or inside.
• The toekick has a
cutout on the left
and right sides.
Remove
the plug on
the left
side and
reinstall
on the
right side.
If you
choose to
install the
stainless steel toekick,
reinstall the plug on the right side
of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick. Install
screws through the spacer standoff, toekick and into
the base as shown.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner’s Manual for more information. Allow 24 hours
for temperature to stabilize.
Turn Right to Lower
Turn Left to Raise
Installation Instructions
Move Fill
Plug to
Right Side
Summary of Contents for Monogram ZDBT240
Page 6: ...6 Notes...
Page 7: ...7 Notes...
