Controls and Features
Beverage Center
Loading
tips and
suggestions
The bottom two full extension drawers
hold six bottles each and are loaded with
necks facing the rear. Tall bottles should
not be loaded on the bottom drawer
because they may prevent the door from
closing.
Do not allow children to climb, stand
or hang on the beverage center shelves
or full extension drawers. They could
seriously injure themselves and possibly
cause damage to the beverage center.
NOTE:
This unit is for storing beverages
only and not intended for the storage of
perishable foods.
Bottom drawer arrangement
Removing
full
extension
drawers
The bottom full extension drawers pull
out so bottles can conveniently be added
or removed.
The upper full extension slide can be
removed for magnums or larger bottles.
To remove:
1.
Pull the full extension drawer out to the
STOP position.
2.
Push the tab on right drawer guide
down while pulling the tab on left guide
up, and pull the drawer out.
To replace:
1.
Push the drawer slide arm back into
the unit.
2.
Pull the small slide sub assembly
completely forward.
3.
Insert the sides of the drawer back
into the guides.
4.
Push until the tabs lock into place.
Tab (push tab down on right
drawer guide, pull tab up on
left drawer guide)
Wood
drawer
fronts
The full extension drawer fronts on the
beverage center are unfinished cherry
wood. During use, oil from hands may
accumulate and stain the wood.
•
The drawer fronts may be stained and
sealed to match adjacent cabinetry. The
tinted glass will make the stained wood
appear darker. A true color match can be
seen only when the door is opened.
•
Apply the stain and sealer according to
the manufacturer’s instructions. To avoid
unpleasant odor, keep the door open to
ventilate and allow the stain/sealer to dry
completely before using the product.
NOTE:
Natural wood may vary slightly in
grain and color.
9
NOTE:
Make sure the tabs on the full
extension drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and
push back in several times to make sure
locking tabs are properly engaged.
To replace, push drawer slide
arm back into unit
Pull small slide sub assembly
completely forward
