GE Mini COM Express 10, Hardware Reference Manual

Page: 31 / 82

5 Configuration
There are no user-configurable
hardware options on the
mCOM10-L1500. The mCOM10-L1500 has been thoroughly tested, and is ready for use in your system. To
verify mCOM10-L1500 operation for the first time, only configure a minimal system. It is
not necessary to have disk drives, a Flash disk, or other accessories connected to perform
the mCOM10-L1500 UEFI boot sequence.
5.1 Hardware
5.1.1 COM Express Type 10 Module Connectors
Refer to the procedure, To
install the mCOM10-L1500
onto the carrier board
.
The COM Express connectors are used to interface the mCOM10-L1500 to the carrier
board. Connect the COM Express receptacle, located on the solder side of the module, to
the COM Express plug on the carrier board.
mCOM10-L1500 Connector Pin Assignments
Pin #
Signal
Pin #
Signal
A1 GND B1 GND
A2
GBE0_MDI3–
B2
GBE0_ACT#
A3
GB
B3
LPC_FRAME#
A4
GBE0_LINK100#
B4
LPC_AD0
A5
GBE0_LINK1000#
B5
LPC_AD1
A6
GBE0_MDI2–
B6
LPC_AD2
A7
GB
B7
LPC_AD3
A8
GBE0_LINK#
B8
LPC_DRQ0#
A9
GBE0_MDI1–
B9
LPC_DRQ1#
A10
GB
B10
LPC_CLK
A11 GND B11 GND
A12
GBE0_MDI0–
B12 PWRBTN#
A13
GB
B13
SMB_CK
A14
GBE0_CTREF
B14
SMB_DAT
A15
SUS_S3#
B15
SMB_ALERT#
A16
S
B16
S
A17
SATA0_TX–
B17
SATA1_TX–
A18
SUS_S4#
B18
SUS_STAT#
A19
S
B19
S
A20
SATA0_RX–
B20
SATA1_RX–
A21 GND B21 GND
A22
USB_SSRX0–
B22
USB_SSTX0–
A23
US
B23
US
A24
SUS_S5#
B24
PWR_OK
A25
USB_SSRX1–
B25
USB_SSTX1–
A26
US
B26
US
A27 BATLOW# B27 WDT
A28
SATA_ACT#
B28
AC/HDA_SDIN2
A29
AC/HDA_SYNC
B29
AC/HDA_SDIN1
Configuration GFK-2896 Hardware Reference Manual 31
For public disclosure