21
P21/P22/P23 Protected Network Station
05-4161A01, Rev. C
Invisible place holder
Figure 18. Mounting Dimensions
3.7 Initial Startup
In-service operation of the Protected Network Station is completely
automatic. Once the unit has been properly installed and configured,
operator actions are limited to observing the LED status indicators for
proper operation.
To prepare for full operation, make sure your Protected Network Station
is properly configured for the desired service. Basic configuration
instructions are provided in this manual for:
• MDS iNET/iNET-II Series transceivers, see “Initial
MDS iNET/iNET-II Programming and Setup” on page 23.
• MDS entraNET transceivers, see “Initial MDS entraNET Pro-
gramming and Setup” on page 30.
• MDS Mercury transceivers, see “Initial MDS Mercury Pro-
gramming and Setup” on page 35..
If all parameters are correctly set, operation of the Protected Station can
be started as follows:
1. Apply primary power.
2. Select the active transceiver by setting the front panel
RADIO SELEC-
TION
switch to
A
,
B
or
AUTO
. (See Table 2 for an explanation of the
switch positions.)
19.05"
484 mm
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8464-MDS-P22-Redundant-Transceiver-Chasis-(Enet).aspx
