4
8
9
Place PSU box onto frame next to unused junction
box and secure with U-bracket by tightening wing nut.
Wing nut
U-bracket
Take the provided safety tether and loop one end
of the tether around the L-bracket.
Loop around
L-bracket
11
10
Attach the other end of the safety tether to the
fixture using one of the three holes located on the
fixture brackets. Feed the button stop and toggle
through the hole and slide into the hole in the
bracket. Allow the fixture to hang freely .
Plug together the light fixture to the driver enclosure
with the supplied quick connects and assemble the
connector housing when finished.
Feed button stop
and toggle through
hole in bracket
Safety
tether
Button stop
Toggle
Assembled connector
housing
Connect two
quick connects
Cut cable tie on light fixture.
Position fixture so
L-bracket does not
interfere with springs
Align the fixture so that two of the three springs are
on each side of the L-bracket. This is necessary in
order to make sure that when the springs release,
the L-bracket does not interfere and prevent the
springs from making contact with the top of the
ceiling for proper support.
12
13
