19
D0404SG0_B
KTD-404 Controller Keypad Installation and Operations Guide
Step 3)
Press
2
. The display will automatically advance to the next menu.
P/T/Z Receiver Preset Position Programming
Receiver Site Select
Step 15)
This menu offers a safety check. If a
3
is entered, the receivers memory will be
reloaded with factory default values. If a
0
is entered, there will be no change.
After the choice is made, the display will return to the Receiver Site Selection menu
display (Figure 29).
Step 16)
Repeat steps 3 - 15 for each receiver in the system.
If a P/T/Z receiver or a KTA-12 series P/T/Z dome is equipped for preset camera positioning
(P option), the receiver can store 10 preset positions in its nonvolatile memory. Each preset
position can be called up individually and, if desired, can also be included in a preset tour (i.e.,
camera automatically pans, tilts, zooms, and focuses through a series of preset positions).
The following procedure explains how preset positions are entered for both purposes.
Step 1)
Access the receiver setup menu as explained on page 16. The first receiver
programming menu will appear as shown below:
Step 2)
Use the numerical keys to select the P/T/Z receiver site to be programmed. The
display will automatically advance to the next menu.
Figure 41: Receiver Setup Menu Display
1=SETUP 2=PRESETS
SEQ=EXIT
Figure 40: Receiver Site Selection Display
ENTER RECEIVER SITE
NUMBER 000 SEQ=EXIT
Setting Electronic Auto Pan Limits for Kalatel Domes
To set the electronic auto pan limits on Kalatel dome receivers, first position the dome at the
limit. While holding down the
zoom
in
and
out
zoom
keys, move the joystick in the direction of the limit
being set.
Example:
To set the left limit, move the dome to the position of the desired left limit.
While holding down the
zoom
in
and
out
zoom
keys, move the joystick left .
Figure 39: Second Clear Memory Display
ARE YOU SURE?
0=NO 3=YES SEQ=NEXT
