MA-005 - Minitrans Installation Manual - Rev 4.5
13-Aug-20
Page 62 of 86
Figure L-15: Attach fittings to isolators
L.5.5
Fit the failsafe mechanism
The following tools and fittings as listed in Table L-5 and as shown in Figure L-16 are
required in order to fit the failsafe mechanism to the support bracket.
Table L-5: Failsafe tools and fittings
Item No.
Description
Qty
5 mm Allen key
10 mm spanner
KAN01056 M6 × 40 stainless steel
bolts
2
KAN02009 M6 nuts
2
KAN03010 M6 flat washers
2
KAN03012 M6 spring washers
2
Figure L-16: Failsafe tools and fittings
▪
Attach the parts for the failsafe mechanism to the remaining threaded inserts in the
support bracket as shown in Figure L-17 and tighten with the Allen key.
Note: If
necessary, use the spanner to tighten the nut (recommended torque is 5 Nm).
Large flat
washers
M6 nut, spring and
flat washers
M6 nut, spring
and flat washers