31-7000173 Rev. 1
35
Locate the two “knockout” plates, on the rear
oven panel, near the top of the oven.
Using tin snips, carefully cut the web area from
the two holes side-by-side (that secure the
knockouts to the oven). Cut all four webs on both
rear knockouts; this will allow the ventilation fan
airflow to exhaust out the rear of the oven.
CAUTION
Be sure to trim the sharp
edges from the openings after removing the
knockout plates.
Place the blower unit back into the opening.
Roll the blower unit 90° so that fan blade
openings are facing out the back of the
oven.
4
AFTER: Fan
Blade Openings
Facing Back
2
1
Remove the two screws that hold the blower
plate and remove the screw holding the blower
motor to the oven. Slide blower plate from under
its retaining flange.
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
B5.
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Replace the blower plate in the same
position as before and replace the screws for
the blower plate and blower motor. Attach the
cover on the blower plate with screw.
Before Rolling
Back of
Oven
After Rolling
Back of
Oven
CAUTION
Do not pull or stretch the
blower unit wiring. Make sure the wires are
not pinched.
NOTE: The blower unit exhaust openings
should match exhaust openings on rear of oven.
Installation Instructions
Blower
Plate
Retaining
Flange
BEFORE: Fan Blade
Openings Facing Up
Back of
Oven
3
Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
After Rotation
Back of
Oven
6
7
Snip all 4 webs
on each knockout
panel and remove
the metal
knockouts for rear
airflow.
Oven Rear Panel
5
Blower Plate
Back of Oven
Blower
Plate
Screws
Blower Motor Screw
Cover Plate
Summary of Contents for JVM3162DJWW
Page 41: ...31 7000173 Rev 1 41 Notes...
Page 83: ...31 7000173 Rev 1 41 Notas...
