31-7000173 Rev. 1
27
ALIGNING THE WALL PLATE
Draw a vertical line on the wall at the center of the 30
”
wide space.
Use the mounting plate
as the template
for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are
touching the bottom of the
cabinet or the level line drawn in Step C for
cabinets with front overhang. Line up the notch
and center line on the mounting plate to the center
line on the wall.
While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D (see
illustration above/actual plate marked with arrows) .
Four holes must be used for mounting.
NOTE:
Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud. It is
important to use
at least one wood screw
mounted
firmly in a stud
to support the weight of the oven.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a
3
/
16
”
hole for wood screws. For holes that don’t line up with
a stud, drill a
5
/
8
”
hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE
AT THIS TIME.
2
3
4
D.
Installation Instructions
1
Draw a
Vertical Line
on Wall from
Center of Top
Cabinet
Area E
Hole A
Hole B
Hole D
Hole C
NOTE:
Appearance and shape of the mounting plate may vary from your model.
CAUTION
Wear gloves to avoid cutting
fingers on sharp edges.
Summary of Contents for JVM3162DJWW
Page 41: ...31 7000173 Rev 1 41 Notes...
Page 83: ...31 7000173 Rev 1 41 Notas...
