8
Find the studs, using one of the following
methods:
A.
Stud finder—a magnetic device which
locates nails.
OR
B.
Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
probing the wall with a small nail to find the
edges of the stud. Then place a mark halfway
between the edges. The center of any adjacent
studs should be 16
"
or 24
″
from this mark.
Draw a line down the center of the studs.
THE OVEN MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
1
Open top of box and remove Styrofoam pack
containing installation instructions, filters, exhaust
adaptor, damper, and the small hardware bag.
Locate cut line at the bottom of the box and
carefully cut along the indicated dotted line.
Then pull the carton up and off the unit.
REMOVING THE OVEN FROM
THE CARTON/REMOVING THE
MOUNTING PLATE
FINDING THE WALL STUDS
B
.
A
.
2
PLACEMENT OF THE MOUNTING PLATE
1
Wall
Studs
Center
3
Cut Line
Remove the styrofoam protecting the front
of the oven. Open the oven door and remove
any contents from inside.
Using a portion of the carton or other material
to protect the outer casing from damage, stand
the oven on its side so the control panel is nearest
to the ground.
The mounting plate is attached to the back
of the oven. Remove the two screws holding
the plate to the oven. The plate will serve
as the rear wall template and provide the support
to mount the oven to the wall.
Once the plate has been removed, set the oven
upright. Remove and properly discard the plastic
bags and Styrofoam.
Check to ensure that all adhesive tape has been
removed from exhaust adapters, grease filters, and
the power supply cord.
2
Installation Instructions
3
6
5
1
4
Control Panel Side
Mounting Plate
7
