ANTI-TIP DEVICE
1. Before placing range in the counter, notice the
location of
stability bracket which is already
attached to the back of the range. This location
should work for most installations. However, it may
be more convenient to hook the stability chain to
the unit when the stability bracket is attached to the
upper set of holes in the back of range. See Fig. A.
The upper level set of holes are intended for use with
a backsplash kit. If the backsplash is not being used,
make sure that there are no structural supports for
the countertop which will interfere with the stability
bracket when located in the upper set of holes.
guard
Bracket
Optional
Location
Bracket
Location
c
2. Fasten one end of
Chain
the stability chain to
—
the floor or wall with
the
screw and
washer supplied. See
the screw is
into the
at the base of the wall or one
of the studs in the base
the wall. See Fig. C.
Whether you attach the chain to the wall or
certain that the screw is in at least 3/4 inch
thickness of wood other than baseboard and that
there are no electrical wires or plumbing in the area
which the screw could penetrate. Attach the stability
chain in a location
will allow the chain to be
in line with the bracket side to aid as much as
possible when attached to the unit. Test to see if the
chain is securely fastened by tugging on the chain.
Chain
Long Screw
,
Wall Plate
Washer
\\\\\\\
3. Temporarily attach the loose end of the chain
to the rear of the countertop with the tape from
the packaging. See Fig. D.
4. Place the range in the counter cutout leaving just
enough room between the back of the range and
the wall to reach the stability bracket.
5. Hook the loose end
the chain onto the bracket
by slipping the nearest link of the chain into the
slot in the bracket. See Fig. A and make sure the
chain is pulled as tight as possible and that there
is no excess slack in the chain after the chain is
attached to the bracket.
r
A
CAUTION: Excessive slack in the chain
could allow the range to tip over.
6. Slide the range all the way back into the counter.
Once the range is pushed back in place, there will —
be a small amount
slack in the chain. This
is normal.
NOTE:
●
If attaching to masonry, you can buy suitable screws
and anchors at hardware stores. Use a masonry drill
to
the required holes.
●
If range is removed for cleaning or any other reason,
make sure chain is reattached.
34
Summary of Contents for JSP38
Page 6: ...FEATURES OF YOUR RANGE Models JSP38 JSP39 JSP40 6...
Page 37: ...NOTES 37...
Page 38: ...NOTES 38...
