GE JP989 Series, Technical Service Manual

Page: 23 / 39

– 21 –
GEA00236
A A
C C
B B
Capacitor Replacement (WB27X10363)
WARNING: Disconnect the electrical power supply
before servicing the capacitor. The capacitor is capable
of storing voltage that could be lethal. Do not touch the
bare connector terminals.
1. Remove the guard surrounding the capacitor shell.
Some models have a flat plastic spacer between the
capacitor shell and the motor. Retain the guard and
the spacer for reassembly.
2. Firmly push upward on the capacitor shell to remove
the capacitor from motor bracket cap.
WARNING: Make sure the stored electrical charge has
been dissipated by placing a 100-ohm, 2-watt resistor
across the terminals, or by placing a screwdriver blade
between the terminals and grounding the screwdriver to
the cooktop for several seconds.
3. Carefully discharge both capacitor wire harness
terminals as described above.
Note: Record wire harness connections.
4. Disconnect terminals using needle nose pliers and
reconnect in same orientation on new capacitor.
5. Firmly snap new capacitor shell casing into motor
bracket cap.
6. Replace plastic spacer (if so equipped) and guard
around capacitor.
HOT Light Replacement
Note: HOT lights can be removed from the cooktop
without removing the cooktop from the countertop.
•
The HOT lights and the surface heater ON light are
120-V lights with dual bulbs (WB25K10003).
•
It is recommended to remove the blower if servicing
the left side HOT lights.
1. Remove the large bottom cover under the HOT
lights.
2. Remove 2 screws (A) and the HOT light bracket.
Caution: Save and replace with the exact screws to
prevent glass breakage (#8-18 x 1/4-in.).
3. Remove the wires (B) to the HOT lights.
4. Compress the HOT light wings (C) and remove
them.
GEA00319
GEA00320
GEA00321
Terminals Terminals Terminals