GE JP392R, Use And Care Manual

Page: 15 / 20

STEP
COOKTOP INSTALLATION
WARNING: Do not install the cooktop if the
glass ceramic cooking surface is broken or
mounting trim is damaged.
NOTE: a non-hardening caulking compound
may be applied to countertop around cutout
in order to form a water tight seal. Remove
any excess compound from countertop after
installation.
Position cooktop over cutout opening and lower
into place. Press gently and evenly, to firmly seat
the cooktop flush with the countertop.
Insert the two clips into slots on cooktop side.
Insert hold-down screws into clips from beneath.
Tighten with Phillips screwdriver until screws
push against the countertop bottom.
CAUTION: Screws should be hand tight only.
Over-tightening will place stress on glass
cooktop surface and may cause breakage.
Clip
2
5/1 6“ x Opening
on Side of Cooktop Case
Should it become necessary to remove the
cooktop, simply back out the two hold-down
screws, remove the two clips and lift cooktop.
STEP 9
CHECKING OPERATION
When the cooktop is first connected, or when
power is restored after a power failure, the light
next to “CONTROL LOCK” lights up to let you
know that the cooktop is locked. The cooktop
controls remain locked until the CONTROL
LOCK pad is pressed twice within 3 seconds.
CONTROL LOCK
To unlock the control
TOUCH TWICE TO
panel, press the CONTROL
LOCK / UNLOCK
LOCK pad twice within
3 seconds. See the Features
of Your Touch Control Panel section on how to
operate your cooktop.
15