GE JP392R, Use And Care Manual

Page: 14 / 20

CONNECT THE ELECTRICAL LEADS
Read the following instructions carefully, and
connect cooktop leads to junction box according
to local codes and type of branch circuit.
Improper connection of service wires will burn
out cooktop power supply.
DO NOT CUT OFF
FLEXIBLE POWER CABLE.
NOTE: The frame of this appliance is grounded
to neutral.
3-Conductor Branch Circuit
When connecting cooktop to a three-conductor
branch circuit, connect the red lead to the branch
circuit red
lead, and the black lead to the branch
circuit black lead. Connect the green conductor
and the white lead of the cooktop to the branch
circuit neutral lead, which is white or gray.
BRANCH CIRCUIT
COOKTOP
RED
RED
WHITE OR
GRAY
NEUTRAL
BLACK BLACK
STEP
4-CONDUCTOR BRANCH CIRCUIT
When
connecting cooktop to a four-conductor
branch circuit, connect the red lead to the
branch circuit red lead, and the black lead to
the branch circuit black lead. Break connection
between the cooktop white lead and the green
conductor. Connect the cooktop white lead to
the branch circuit neutral lead, which is white or
gray. Ground the unit by connecting the green
conductor of the cooktop to the branch circuit
bare or green lead (ground lead).
BRANCH CIRCUIT COOKTOP
RED RED
-7&--
WHITE OR
GRAY
NEUTRAL
WHITE
BLACK
BLACK
BARE OR
GND
GREEN GREEN
STEP 7
DRIP TRAY INSTALLATION
Before inserting the cooktop in the counter,
install the two drip trays as follows:
●
Remove two drip trays that were mounted
on the rear of the unit for shipment and install
as follows.
. Install the largest drip tray under the right rear
corner (behind touch control) of the cooktop as
shown in the illustration below. First insert the
tab of tray under housing tab and drive screw
through hole in enclosure into tray tab.
●
Install the smallest drip tray under the left rear
corner of the cooktop using the same procedure
as above.
INSERT TAB OF TRAY UNDER HOUSING
AND RETAIN BY DRMNG SCREW THROUGH
HOLE IN ENCLOSURE INTO TRAY TAB.
14