GE JGSP28SENSS, Owner'S Manual

Page: 21 / 36

21
How to Delay the Start of Cleaning
Make sure the clock shows the correct
time of day.
Latch the door.
Touch the
SELF CLEAN pad.
Using the + or – pads, enter the
desired clean time.
The Clean Time is normally 4 hours. You can
change the Clean Time to any time between
3 and 5 hours, depending on the amount of
soil in your oven.
Touch the START TIME pad. The
earliest start time you can set will
appear in the display.
Using the
+ or – pads, enter the time
of day you want the clean cycle to
start.
Touch the
START/ON pad.
The display will show the start time set
time. It will not be possible to unlatch the
oven door until the temperature drops
below the lock temperature and the clean
light goes off.
When the clean light is off, unlatch the
door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse
thoroughly with a vinegar and water
mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
n
You cannot set the oven for cooking until
the oven is cool enough for the door to
be unlatched.
n
While the oven is self-cleaning, you can
touch the CLOCK pad to display the time
of day. To return to the clean
countdown, touch the COOKING TIME
pad.
n
Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven racks with the paper towel. Do not
spray with Pam
®
or other lubricant
sprays.
GEAppliances.com
To Stop a Clean Cycle
Touch the CLEAR/OFF pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door.
You will not be able to open the door right
away unless the oven has cooled below
the locking temperature.