23
The oven door must be closed and all controls set correctly for the cycle to work properly.
After a Clean Cycle
You cannot set the oven for cooking until
the oven is cool enough for the door to be
unlatched.
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the
oven cools.
If white spots remain, remove them with a soap-
filled steel-wool pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
■
You cannot set the oven for cooking until
the oven is cool enough for the door
to unlock.
■
While the oven is self-cleaning, you can
touch the
CLOCK
pad to display the time
of day. To return to the clean countdown,
touch the
COOKING TIME
pad.
■
If the shelves become hard to slide,
apply a small amount of vegetable oil or
cooking oil to a paper towel and wipe
the edges of the oven shelves with the
paper towel.
GEAppliances.com
How to Delay the Start of Cleaning
You can set the oven control to delay-start the oven,
clean for a specific length of time and then turn off
automatically.
Make sure the clock shows the correct time
of day.
Follow the directions in the
Before a Clean
Cycle
section.
Latch the door.
NOTE:
Never force the latch. If the oven is
too hot, you will not be able to slide the
latch. Allow the oven to cool.
Touch the
SELF CLEAN
pad.
Touch the
+
or
–
pads to set the
Clean Time.
The Clean Time is preset for 4 hours and 20 minutes.
You can change the Clean Time to any time between
3 and 5 hours, depending on the amount of soil in
your oven. If a different Clean Time is desired, touch
the + or – pads until the desired Clean Time is
displayed.
Touch the
START TIME
pad.
Change the Start Time by touching the + or – pads.
The start time will appear in the display.
Touch the
START/ON
pad.
The self-clean cycle will automatically begin
at the time set.
While the oven is self-cleaning, you can
touch the
CLOCK
pad to display the time
of day. To return to the clean countdown,
touch the
SELF CLEAN
pad.
The oven shuts off automatically when the
clean cycle is complete, and 0:00 will flash
in the display.
Slide the latch handle to the left as far
as it will go and open the door.
To Stop a Clean Cycle
Touch the
CLEAR/OFF
pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door.
You will not be able to open the door right
away unless the oven has cooled below the
locking temperature.
Operating
Instructions
Care and Cleaning
Installation
Instructions
Tr
oubleshooting T
ips
Safety Instructions
Consumer Support
