Simon Security System
6
HOME CONTROL
The Home Control buttons are used to monitor activity within and around the home.
They are not used for intrusion protection. If any of the Home Control buttons are
pressed and a sensor or module is not associated (programmed) with this feature the
panel will announce,
Function not available
.
Chime Doors
Chime Doors is used to signal (chime) when a protected door is opened while the sys-
tem is disarmed. The panel will announce the door that has been tripped and chime
twice (ask your installer how this feature is programmed). This is a nice feature to use if
you’re busy in one part of your home and you want to know when family members are
going in and out of your home.
¾
Turn Chime Doors on:
1.
System must be disarmed. Press
Chime Doors
button
.
Panel will announce,
Chime on.
Chime Doors
button will be lit.
¾
Turn Chime Doors off:
1.
Press
Chime Doors
button
Panel will announce,
Chime off.
Chime Doors
button no longer lit
Chime Special Motion
Note
If there are no Special
Motion Chime sensors in
your system, the Chime
Special Motion button can
be used for Direct Bypassing
and Unbypassing. See the
Arming Your System with
Direct Bypassing
and
Arm-
ing Your System with
Direct Unbypassing
sec-
tions for more information.
This is used to detect movement within a specific area. These Motion Sensors are not
used for intrusion protection. The panel will chime three times and announce (see
Option 41) the sensor that has been tripped. Use the same panel procedures as
Chime
Doors,
except, with the
Chime Special Motion
button.
If you have Motion Sensors located in areas such as in a patio area or at the front door
and you want to know when someone is approaching these areas, you would use this
feature.
Direct Bypassing
Direct Bypassing refers to turning off (bypassing) certain sensors while the system is
armed.
Note
You can only use this feature
if there are no Special
Motion Chime sensors in
your system.
1.
Press the
Bypass
button until you reach the sensor to be bypassed (sensor must cur-
rently be unbypassed).
2.
Enter Master Code
Direct Unbypassing
Direct Unbypassing refers to turning on (reactivating) bypassed sensors while the sys-
tem is armed.
Note
You can only use this feature
if there are no Special
Motion Chime sensors in
your system.
1.
Press the
Bypass
button until you reach the sensor to be unbypassed (sensor must
currently be bypassed).
2.
Enter Master Code.
OR
Change arming level.
Time Activated Lights
Turn on designated lights (with Lamp Modules) at a specific time. You can program
what time the lights go on and off (see Programming - Light Control).
¾
Turn Time Activated Lights on:
1.
Press
Time Lights
button.
H O M E C O N T R O L
O f f
O n
S e n s o r
T i m e
L i g h t s
M o t i o n
D o o r s
C h i m e
B y p a s s
