GE GSH22JFR, Owner'S Manual And Installation Instructions

Page: 15 / 72

The rollers have 3 purposes:
Rollers adjust so the door closes easily when opened
about halfway.
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollers, remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting screws clockwise to raise the
refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8
″
hex head bolt) or pliers.
To replace base grille, line up the clips on back of grille
between the bar and the bottom of the cabinet. Push
forward until grille snaps into place.
ROLLERS
Installation Instructions
The water line installation is not warranted by the
refrigerator or icemaker manufacturer. Follow these
recommendations carefully to minimize the risk of
expensive water damage.
Water hammer (water banging in the pipes) in house
plumbing can cause damage to refrigerator parts and
lead to water leakage or flooding. Call a qualified
plumber to correct water hammer before installing
the water supply line to the refrigerator.
To prevent burns and product damage, do not hook
up the water line to the hot water line.
If you use your refrigerator before connecting the
water line, make sure the icemaker power switch is
in the
O (off) position.
BEFORE YOU BEGIN
Do not install the icemaker tubing in areas where
temperatures fall below freezing.
When using any electrical device (such as a power
drill) during installation, be sure the device is
insulated or wired in a manner to prevent the hazard
of electric shock.
All installations must be in accordance with local
plumbing code requirements.
Installation of the icemaker must be done by a
qualified service technician.
WARNING!
Connect to potable
water supply only.
BEFORE YOU BEGIN
(CONT.)
INSTALLING THE WATER LINE
15
DOOR ALIGNMENT
After leveling, make sure that the doors are even at the top.
To make the doors even, adjust the refrigerator door as follows:
Remove the Base Grille, open the doors, then pull the
grille straight out.
Determine which of the two doors is higher than the other.
Lift the lower door, along with the small cam.
Place the shim between the Door Metal Hinge and the
small cam as shown.
Press in the shim so that it fits in between the metal
hinge and the plastic cam.
Close the doors and check if they are level at the top.
If one door is still lower than the other, repeat the
process and insert another shim.
NOTE: If the doors are not even and the shim is already
inserted, you can remove the shim to lower the door.
Shim
Shims are stored
under the fresh food
door top hinge cover.