GE FL000090, Service Manual

Page: 121 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 3 - System Setup 3-53
NOTE: Installation of Carto3 and the required VGA splitter (to connect to the Vivid i n/ Vivid q N) shall be done
by the BWI field engineer according to the BWI manuals and instructions.
WARNING: To avoid possible electrical shock to user or patient, the Vivid
i
n/ Vivid q N should
be connected to the Carto3 only by using the Isolated VGA Splitter.
NOTE: Vivid i n/ Vivid q N-to-Carto3 VGA Cable Installation:
A GE Field Service Engineer must be present when connecting the VGA cable (top right in
Figure 3-52 )
between the Vivid i n/ Vivid q N system and the GE Video Splitter/Isolation box.
1.) Connect the VGA cable ( Figure 3-52 ) to the VGA input port at the rear of the VGA splitter
(see Figure 3-53 and Figure 3-54 ).
Connect the other end of the cable into the Vivid i n/ Vivid q N system’s VGA output port.
2.) Plug the VGA Splitter power cable ( Figure 3-52 ) into the power socket on the rear of the VGA
Splitter (see Figure 3-53 and Figure 3-54 ).
Plug the other end of the power cable into the mains power wall outlet.
Figure 3-53 VGA Splitter - Rear View
Figure 3-54 Connections to VGA Splitter
Connect VGA Cable Connect Power Cable
Interface Connections