Main Menu
→
Alarms
→
Link To A Macro
Use this menu to link an alarm input to a macro. If a link is created,
a macro will run each time that alarm is activated.
Alarm:
Select the alarm input you would like to link.
Macro:
Select the macro number you wish to link to. Leave this
setting blank if you do not wish to link to a macro.
Rotate the
Jog
to navigate, and the
Shuttle
to change
the values.
Save changes and exit the menu:
Select
[OK]
, then press the
Enter
button.
Exit the menu without making changes:
Press the
Menu
button, or select
[CANCEL]
, then press the
Enter
button.
Main Menu
→
Alarms
→
Fullscreen Alarm
Selecting
Yes
from this menu will cause the unit to always display
the alarm camera fullscreen.
Selecting
No
from this menu will cause the unit to display the 4-way
display configured in the
Main Menu
→
Alarms
→
Alarm Action
Setup
menu.
This menu selection is not available on 4-channel DVMRe CT II units, since Fullscreen Alarm Mode is the
only alarm mode available.
Fullscreen Alarm
Fullscreen
NO
Main Menu
→
Alarms
→
Relay Configuration
Use this menu to configure each relay output as either:
Relay Configuration
[CANCEL] [OK]
Relay 01:
Relay 02: N/CLOSED
N/OPEN
•
Normally Open
•
Normally Closed
Main Menu
→
Alarms
→
Buzzer Setup
Use this menu to configure the internal buzzer.
Global Buzzer:
The Global Buzzer setting acts as a master On/Off
switch. Setting the Global Buzzer to
OFF
deactivates all buzzer
activity.
Live Alarm Buzzer:
Activates while receiving alarm input.
Videoloss Buzzer:
Activates when video loss is detected.
Disabling the Videoloss buzzer disables all videoloss buzzer activity.
Videoloss buzzers may be disabled on a per camera basis in the
Alarms
→
Videoloss Action
menu.
Playback Buzzer:
Activates during playback of recorded alarms.
Disk Monitor Buzzer:
Activates if a disk test has failed.
0150-0313B 44
DVMRe
CT II
Summary of Contents for DVMRe CT II
Page 1: ......
Page 96: ...0150 0313B ...