GE Druck ADTS 405, Service Manual

Page: 39 / 64

Druck ADTS 405 Service Manual
K0171 Issue No. 1 Page 3-5
Display and key-pad panel
30. Locate the key-pad and display on the front panel and secure the display with the four screws
and washers.
31. Connect the two-pin and ribbon cable connectors to the display.
Front Panel
Caution: Do not trap any cables between front panel and rear chassis.
32. Locate the four screws through the holes in the front panel, above and below each handle.
Secure the front panel to the side panels.
33. Invert the partially assembled rack and secure the base plate along the front edge with five
screws and shakeproof washers. Reposition the partially assembled rack.
IEEE 488 Interface PCB
Note: Make sure the PCB connections are correctly aligned on the motherboard.
34. Carefully insert the PCB into motherboard and align the holes in the PCB bracket with the rear
panel of the rack.
35. Secure the PCB with the two screws and plain washers.
36. Connect the ribbon cable connector to the top edge of the PCB and secure with the two clips.
Altimeter Encoder Interface PCB
Note: Make sure the PCB connections are correctly aligned on the motherboard.
37. Carefully insert the PCB into motherboard and align the holes in the PCB bracket with the rear
panel of the rack.
38. Secure the PCB with the two screws and plain washers.
39. Connect the ribbon cable connector to the top edge of the PCB and secure with the two clips.
ARINC 429 Interface PCB
Note: Make sure the PCB connections are correctly aligned on the motherboard.
40. Carefully insert the PCB into motherboard and align the holes in the PCB bracket with the rear
panel of the rack.
41. Secure the PCB with the two screws and plain washers.
42. Connect the ribbon cable connector to the top edge of the PCB and secure with the two clips.