Installation Preparation–Enclosure
3
Countertop: 1-1/2" Min. Thick
10-1/4"
Max.
Area "A"
Area "B"
Area "C"
Front View
7-1/2"
923-38C
Toekick
Area
Floor
24"
12"
Min.
6" Max.
PREPARE DISHWASHER ENCLOSURE AND
SINK LOCATION
• Water line to sink faucet and drain from sink can
be run through Area “A.”
• Hot water line to dishwasher is installed in Area “B.”
• Garbage disposer, water lines to faucet, waste
trap, air gap and water shut-off valve are installed
in a 12" wide cabinet, Area “C”.
Figure B
Figure A
• Sink opening for garbage disposer must be
dimensioned as shown (7-1/2") in Area “C.” This will
provide clearance for disposer and plumbing in
Area “C” when using either single or double bowl
sink. Refer to Figure A below and Figure F1 on
page 6.
PREPARE CABINET CUTOUT FOR SINK:
#282 French
To reduce the risk of shock, fire, or injury to
persons, the installer must ensure that the
dishwasher is completely enclosed at the
time of installation.
WARNING
Note:
A gap between the dishwasher tub front flange and
the front of the base cabinet may result due to either
the cabinet being less than 24" deep or the sink bowl
not being installed to specifications.
If the gap is more than 3/4", the sink bowl must be
relocated to meet specified dimensions.
Cabinet Side
Adjacent to D/W
Sink
Installation
Cutout
8" X 20"
Adjacent Cabinet
Rear Cutout
12"
3-1/4"
12-1/2"
24”
min
24” min
5"
5"
697DiaJ
Dishwasher
Side View
11-3/4" Max.
Plumbing
4"
Max.
34-1/4"
1/4"
+_
10-1/4" MAX.
PLUMBING
DEPTH
1" Max. To
Sink Flange
20-1/2" Max.
Sink Bowl
11" Min.
Drain
6" Max.
3/4" Min.
1-1/4"
1-1/2"
Close Elbow
Min. I.R.
24" Min.
Cabinet
Wall
679DiaA
B
A
Dishwasher
Tub
Front
Flange
20-1/2" Max.
Sink Bowl
24" Min.
Cabinet
Wall
679DiaK
Gap
• The dishwasher must be fully enclosed on the top,
sides and back.
• The dishwasher must not support any part of the
enclosure.
• The cabinet opening must have a minimum width
and depth of 24" and height of 34-1/4" ± 1/4".
• This dishwasher fits under a special sink with a
depth of 6" or less in a 1-1/2" countertop.