GE DBVH520GJ, Installation Instructions Manual

Page: 7 / 14

DUCT
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.
DUCT
TAPE
Installation Instructions
Detach and remove the bottom or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Protect sharp edges
around the knockout and exhaust opening with the tape.
7
ADDING NEW DUCT
•
Pre-assemble 4" elbow with 4" duct. Wrap duct tape around
joint.
•
Insert duct assembly, elbow first, through the side opening
and connect the elbow to the dryer internal duct.
CAUTION: Be sure not to pull or damage the
electrical wires inside the dryer when
inserting the duct.
WARNING - PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE CABINET.
Cut the duct as shown and keep portion A.
TAB LOCATION
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45° using a flat
blade screwdriver.
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the fixing hole is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST
TO SIDE OF CABINET
•
Apply duct tape as shown on the joint between the dryer
internal duct and the elbow.
12 DRYER EXHAUST TO LEFT OR
BOTTOM OF CABINET
REMOVE
SCREW
AND SAVE.
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
BEND TAB
UP 45°
LEFT SIDE
EXHAUST
PORTION "A"
FIXING
HOLE
FIXING HOLE
11.25"
A B