GE CSWDMBLBWF1NN, Installation Manual

Page: 3 / 13

Compatibility Requirements
Rating 120V AC 60Hz
Neutral wire is not required
(Wire is usually white or grey and
is not required)
Ground wire is required
(Wire is usually green, green with
a yellow stripe, or copper)
Wi-Fi 802.11 b/g/n @ 2.4 GHZ is
required
Works with halogen,
incandescent, and LED bulbs,
including C by GE and Cync
Smart Bulbs
Not for use with ceiling fans
LED up to 1.25 amps (150 Watts)
Incandescent/halogen up to
5 amps (450 Watts)
Minimum Load 15 Watts
If you are using less than 15
Watts, non-dimmable LED bulbs,
or C by GE or Cync Smart Bulbs
on the circuit, you will need to
use the included Bulb Adaptor
Use the optional Fixture Adaptor
(available separately) where the
Bulb Adaptor will not fit.
Contact Customer Support at
1-844-302-2943 for details.
! IMPORTANT NOTE ON 3-WAY WIRING:
Some lights have one wall switch, while others are controlled by two
or more wall switches (such as stair lights, which have a switch at
both the top and bottom of the stairs). If your lights have more than
one switch (called a 3-way), we’ve created other instructions for this
type of installation.
12
6
3 9
Let’s Do It
INCLUDED
YOU’LL NEED
On/Off Switch Wall Plate 4 Wire Nuts
Needle Nose Pliers
(recommended)
Voltage Tester
(recommended)
Approximately 30
minutes of your day
to install and set up
the switch
Phillips Screwdriver
Line/Load Line/Load Ground
Wire Labels
6 Phillips
Mounting Screws
Bulb Adaptor