10
Installation Instructions
Installing the Lower Oven
Rack Supports and Oven
Racks
C4
Oven Rack Supports
Place the rack support with slotted holes over
the rear bolts and round holes over the front
bolts. Using a nut driver 7/16” (11 mm), lightly
secure with four nuts but do not overtighten or
the enamel could be chipped. Repeat for the
second rack support.
Oven Racks:
Place the rear rack lock bar over and onto the
rack supports, slide the rack all the way in until
the rear rack lock bar drops below the rack
supports. Pull rack forward and make sure the
rear rack lock bar is engaged under the rack
support.
WARNING:
Mounting screws
must be used. Failure to do so could
result in the oven falling out of the
cabinet causing serious injury.
Drilling the Pilot Holes and
Mounting the Oven
a. Drill through the mounting holes of the side
trim, for the #8 screws provided.
b. Secure the oven to cabinet with screws
provided.
NOTE: If the cabinet is particle board, you must
use #8 x 3/4” particle board screws. These may
be purchased at any hardware store.
NOTE: Before drilling the pilot holes, make
sure the oven is pushed as far back into
the opening as it will go and centered.
C3
Mounting Hole
Locations
(two provided)
Slotted
holes over
rear bolts
Round
holes over
front bolts
