www.GEAppliances.com
The display will always default to show the
room temperature.
When the air conditioner is turned on, it will
automatically start in the last mode and fan settings
selected.
COOL Mode
Use the
COOL
mode for cooling.
To set the COOL mode:
1.
Press the
MODE
pad until the
COOL
indicator
light is lit.
2.
Press the
FAN
pad to set
HIGH, MEDIUM
or
LOW
fan speed.
3.
Press
or
to set the desired temperature
between 64°F and 90°F in 1°F increments.
After settings have been made, the display will
change back to show the room temperature.
The temperature control is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the temperature control at a lower number
and the indoor air will become cooler. Set the
temperature control at a higher number and the
indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
COOL
, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
or
MEDIUM
fan speed with a middle set
temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH
fan speed with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
COOL
mode and
LOW
fan speed with a middle set
temperature.
NOTE:
If you switch from a
COOL
setting to
OFF
or to
a fan setting, wait at least 3 minutes before switching
back to a
COOL
setting.
FAN Mode
Use the
FAN
mode to provide air circulation and
filtering without cooling.
To set the FAN mode:
•
Press the
FAN
pad until the desired indicator light
for
HIGH, MEDIUM
or
LOW
fan speed is lit.
Since fan only settings do not provide cooling, a set
temperature will not be displayed. After
FAN
speed
has been set, the display will change back to show
the room temperature.
DRY Mode—Dehumidification
Use the
DRY
mode to provide dehumidification
only. The fan will run at a fixed speed at this setting,
so a fan speed cannot be set. Keep windows and
doors closed for the best dehumidifying effects.
The exhaust hose must be attached to the unit
when using the
DRY
mode.
To set the DRY mode:
•
Press the
MODE
pad until the
DRY
indicator light
is lit.
In the
DRY
mode, a set temperature will not be
displayed. After
DRY
mode has been set, the display
will change back to show the room temperature.
NOTE:
If you switch from a
DRY
setting to
OFF
or to a
fan setting, wait at least 3 minutes before switching
back to a
DRY
setting.
If using the unit in the DRY mode for an extended time:
1.
Unplug the power cord.
2.
Roll the unit so that its drain nozzle is located over
a floor drain and pull out the drain cap from the
back bottom edge. A water hose (not included)
may also be attached to the nozzle and led to a
floor drain. Reconnect the power cord.
3.
Press the
MODE
pad until the
DRY
indicator light
is lit.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Care and Cleaning
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored.
NOTE:
If the
TIMER
was set before the power outage,
it will need to be reset after power is restored.
5