49-5000610 Rev. 0
7
INST
ALLA
TION INSTRUCTIONS
Installation Instructions
TOOLS YOU WILL NEED
Phillips head screwdriver
Ruler or tape measure
Pencil
Level
Scissors or knife
Drill and 1/8” drill bit
ELECTRICAL REQUIREMENTS
(CONT)
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case.
The device should be tested on a periodic basis
by first pressing the
TEST
button and then the
RESET
button while plugged into the outlet. If the
TEST
button does not trip or if the
RESET
button
will not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.
CAUTION
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord of this
air conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all governing
codes and ordinances.
• Note to Installer
– Be sure to leave these
instructions with the Consumer.
• Note to Consumer
– Keep these instructions for
future reference.
• Skill level
– Installation of this appliance requires
basic mechanical skills.
• Completion time
– Approximately 1 hour
• We recommend that two people install
this product.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
ELECTRICAL REQUIREMENTS
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall
outlet you plan to use is only a 2-prong outlet,
it is your responsibility to have it replaced with
a properly grounded 3-prong wall outlet.
These models require 230/208-volt AC, protected with
a time-delay fuse or circuit breaker. These models
should be installed on their own single branch circuit
for best performance and to prevent overloading
house or apartment wiring circuits, which could cause
a possible fire hazard from overheating wires.
Questions? Visit our Website at: GEAppliances.com
