www.GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the last cool and fan
settings used.
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOL Mode
Use the
COOL
mode with
HIGH (F3), MED (F2)
or
LOW (F1)
fan for cooling. Use the
INCREASE
▲
/
DECREASE
▼
pads to set the desired temperature
between 60°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
COOL
, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling–
Select the
COOL
mode and
HIGH (F3)
or
MED (F2)
fan with a middle set
temperature.
For Maximum Cooling–
Select the
COOL
mode
and
HIGH (F3)
fan with a lower set temperature.
For Quieter & Nighttime Cooling–
Select the
COOL
mode and
LOW (F1)
fan with a middle set
temperature.
NOTE:
If you switch from a
COOL
setting to
OFF
or to
a fan setting, wait at least 3 minutes before switching
back to a
COOL
setting.
FAN Mode
Use the
FAN
at
HIGH (F3), MED (F2)
or
LOW (F1)
to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
5
Air Direction
Fingertip pressure on the louvers lets you control
the air direction left, right, straight ahead or any
combination of these directions.
Additional controls and important information.
