4
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
■
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■
The remote control signal has a range
of up to 21 feet.
■
Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
■
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
FAN
Air Conditioner Controls
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to
COOL
or
FAN
mode.
Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
COOL
mode.
FAN Pad
Use to set the fan speed to
LOW (F1), MED (F2)
or
HIGH (F3).
ENERGY SAVER (on some models)
Controls the fan.
ON—
The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied.
Note:
The fan
will continue to run for a short time after the
compressor cycles off.
OFF—
The fan runs all the time, while the
compressor cycles on and off.
This feature must be set at
OFF
in order to
use the fan settings (on the mode control).
Note:
On some models, the
ENERGY SAVER
feature cannot be set on the air conditioner.
It must be set using the remote control.
CIRCULAIRE (on some models)
For continuous side-to-side air circulation
(cool settings only), set the Circulaire switch
to
ON
.
For fixed side-to-side air direction, turn
ON
until the desired air direction is obtained,
then turn it
OFF
.
TIMER Pad
ON—
When the air conditioner is off, it can be
set to automatically come on in 1 to 12 hours
at its previous setting. Each touch will set the
timer in hours.
OFF—
When the air conditioner is on, it can
be set to automatically turn off in 1 to 12
hours. Each touch will set the timer in hours.
To cancel the timer,
press the
TIMER
pad until
the display time disappears.
Remote Control Signal Receiver
Remote Control
Remote Control
Cool on
Fan on
Energy
Saver on
Timer on
Timer
on
Energy
Saver on
Cool on
Fan on
