GE AEV07KP, Use & Care Manual

Page: 13 / 20

Operation Procedure
Operation Pr
ocedur
e
11
3
Temp Increase
▲
/Decrease
▼
Buttons
Use to set temperature except Auto mode.
4
Delay Timer Increase
▲
(+) /Decrease
▼
(-) Buttons
Each touch of the Increase
▲
/ Decrease
▼
buttons on the unit or the I / Decrease - buttons
on the remote control will set the delay time when using the Delay 0.5-24hr timer (DELAY).
5
Fan Speed Buttons
Use to set the fan speed to Low, High, Turbo or Auto on the unit .
NOTE:
On the remote control, use the fan speed I /Decrease - buttons to set the fan speeds to Low,
High or Turbo. Use the Auto button to turn Auto fan on.
6
Mode Button
Use to set the air conditioner to Cool, Auto Fan Only mode.
7
Delay Button
Delay ON – When the air conditioner is off, it can be set to automatically come on in 0.5 to 24 hours at
its previous mode and fan settings.
Delay OFF – When the air conditioner is on,it can be set to automatically turn off in 0.5 to 24 hours.
How to set:
Press the Delay 0.5-24hr button on the unit or the Delay button on the remote control. Each touch of
the Increase
▲
/ Decrease
▼
buttons on the unit or the I / Decrease - buttons on the remote
control will set the timer in 0.5-24hour intervals.
To review the remaining time on the Delay 0.5-24hr timer, press the Delay 0.5-24hr button on the unit
or the Delay button on the remote control. Use the Increase / Decrease buttons on the unit or the
I / Decrease - button on the remote control to set a new time if desired. During preview of
timer or timer setting, press Delay 0.5-24hr button on the panel or Delay button on the remote controller
to cancel the timer setting.
Remote Control
■
To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■
The remote control signal has a range of up to 20 feet.
■
Make sure nothing is between the air conditioner and the remote control that could block the signal.
■
Make sure batteries are fresh and installed correctly as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, High, Turbo or Auto Fan Speed for cooling. Use the Temperature Increases
▲
/
Decrease
▼
buttons to set the desired temperature between 16°C (61°F) and 30°C (86°F) in 1°C (1°F)
increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to
a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.