49-7805-3
5
Controls
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Fan
Fan
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Auto Fan on
Fan speed
Increase
Unit power
on/off
NOTE:
The display always shows the room temperature except
when setting the set temperature.
Light indicates
WiFi connection
Light indicates the unit is in
the temperature set mode.
Controls
NOTE: When the bucket is full or removed, the controls cannot be
set.
1. Power Pad
Turns air conditioner on and off. When turned on, the display
will show the room temperature.
2. Display
Shows the room temperature. Shows the Set temperature
while setting the temperature in Cool or ECO modes. The Set
light will turn on while setting.
3. Temp In /Decrease - Pads
Use to set temperature when in Cool or ECO mode. The Set
light will turn on while setting.
4. Fan Speed Pads
Use to set the fan speed to Low, Med, High or Auto on the unit.
NOTE: On the remote control, use the fan speed In /
Decrease – pads to set the fan speeds to Low, Med or High.
Use the Auto pad to turn Auto fan on.
5. Mode Pad
Use to set the air conditioner to Cool, ECO or Fan Only mode.
6. WiFI
Enables connection of the air conditioner to the home WiFi.
Download App for details at GEAppliances.com/connect.
7. Reset Filter
LED will turn on when fan has accumulated 250 hours of run
time as a reminder to clean filter. Press Reset Filter to turn off
the LED and reset the accumulated run time.
NOTE: The default temperature reading on the display is
degree Fahrenheit ( °F). To change the display to degree
Celsius (°C), press the Temp In and Temp Decrease -
buttons together and hold for 3 seconds. Repeat the process
to change back to degree Fahrenheit (°F)
8. Control Display On and Off
To reduce brightness during sleeping hours, this air conditioner
control display has an automatic off feature where the control
display will turn off completely after 5 minute of inactivity. To
illuminate the control interface, press any button on the control
display or remote control. The control display will illuminate all
previously illuminated LED’s. The control interface will now
respond to any prescribed button press after it is illuminated.
Press and hold the FAN+MODE button for 3 seconds to toggle
this feature ON or OFF. The LED’s will now stay ON anytime
the unit is ON.
9. Control sound on/off
This air conditioner will make a beep when the buttons on the
control are pushed or if the unit receives a command from
the mobile app or remote control. To silence these beeps,
simultaneously press the FAN and “-” buttons for 3 seconds.
Press these buttons again to toggle the sound back on.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
■ To ensure proper operation, aim the remote control at
the signal receiver on the air conditioner.
■ Make sure nothing is between the air conditioner and
the remote control that could block the signal.
■ The remote control signal has a range of
up to 20 feet.
■ Make sure batteries are fresh and installed correctly as
indicated on the remote control.
■ Remote contains a magnet allowing it to attach to
metal surfaces.
Auto
High
Med
Low
Cool
Fan
Eco
Reset
Filter
Fan
Mode
Power
WiFi
8
Summary of Contents for AEC14
Page 16: ...16 49 7805 3 NOTES Notes...
Page 34: ...16 49 7805 3 NOTA Nota...
