GE ADTS552F, Safety And Installation Manual

Page: 13 / 144

K0554 Revision A 9
Hoses (available as orderable accessories on the datasheet) are used for connection to
the “Pitot” (Pt) (1) and “Static” (Ps) (2) output ports of the ADTS.
The “Pitot” (Pt) and “Static” (Ps) outputs can then be connected to the corresponding Pitot
and Static connectors on the aircraft or aeronautical instruments.
The maximum Pt and Ps output pressure is 2bar absolute.
The following table details the possible connector specifications:
Mating female parts are available from GE.
3.4 Cleaning
CAUTION
DO NOT USE SOLVENTS TO CLEAN THIS EQUIPMENT.
The following materials are approved cleaning agents:
Note: Equivalent alternatives may be used for listed items.
1. Clean the external surfaces of the unit using lint-free cloth and a soft brush. Remove
stubborn dirt using a damp cloth and mild detergent and allow to dry.
2. Clean the electrical connector using a soft brush. Remove stubborn dirt using a damp
cloth and mild detergent and allow to dry.
4 Product labelling
The product label for the base unit can be found in the bottom right hand corner of the
front panel. The product label for the ADTS Touch can be found on the rear of the ADTS
Touch.
Labelling information consists of:
G1/8 Pipe Thread ISO 228 - G 1/8 B
AN3 3/8 - 24 UNJF - 3A Thread
AN4 7/16 - 20 UNJF - 3A Thread
AN6 9/16 - 18 UNJF - 3A Thread
Material Specification
Lint-free cloth Commercially available
Damp cloth -
Mild detergent Commercially available
Soft brush Commercially available
Company logo and product name
Part number
Serial number
Date of manufacture (DOM)
Name and address of manufacturer