4
Getting started!
Load Dishwasher
For best dishwashing results, follow the rack loading guidelines found in the
Loading the dishwasher racks
section. No pre-rinsing of
normal food soil is required. Scrape off hard soils, including bones, toothpicks, skins, and seeds. Remove leafy vegetables, meat trimmings,
and excessive amounts of grease or oil. Remove acidic food soils that can discolor stainless steel.
Add Detergent
Add needed amount of detergent to the detergent dispenser. Use a detergent such as
Cascade Complete All-in-1 ActionPacs™
. See
Detergent
Dispenser
in the
Using the dishwasher
section.
Add Rinse Agent
Add Rinse Agent to the rinse agent dispenser. See
Use a Rinse Agent such as Cascade
®
Rinse Aid™
in the
Using the dishwasher
section.
Select Cycle
Press the
Select Cycle
pad for the desired wash cycle. The light next to the
Select Cycle
pad will be on to indicate which wash cycle has been
selected.
The cycle may be selected with the door in the open position. The cycle will not start until after the door is closed and
Start
selected.
AutoSense
This cycle automatically senses the soil level and adjusts the wash cycle accordingly.
(on some models)
Heavy
This cycle is meant for heavily soiled dishes, cookware, pots, or pans with dried-on or baked-on soils.
Everyday dishes are safe to be used in this cycle.
Normal
This cycle is meant for normal everyday soil levels and is designed to conserve both water and energy.
NOTE: Normal
was used to rate the energy efficiency of this dishwasher.
Light
This cycle is for light to medium soiled dishes. It is safe for china and crystal.
Rinse
For rinsing partial loads that will be washed later. Do not use detergent. Detergent is not dispensed during the
(on some models) rinse cycle.
Select Options
The light by the selected pad will be
ON
to indicate which Option has been selected.
Wash Temp
This option increases the temperature to help clean heavily soiled dishes and may increase the overall cycle time.
Boost
Option may be turned
On
or
Off
during the wash cycle.
(on some models)
Wash Temp
This option raises the water temperature in the final rinse to sanitize your dishware. The cycle length will
Sani
vary depending on the temperature of your inlet water.
(on some models)
NOTE
:
This option is monitored for sanitization requirements. If the cycle is interrupted during or after the main
wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved,
the sanitizing conditions may not be met. In these cases, the Sanitized light will not illuminate at the end of the
cycle. Utilizing this option will modify the cycle to meet the requirements of Section 6, NSF 184 for soil removal
and sanitization efficacy.
NOTE:
NSF certified residential dishwashers are not intended for licensed food establishments.
Heated Dry
Shuts off the heat drying option. Dishes air dry naturally and energy is saved. Open the dishwasher door to
Off
speed drying.
Heated Dry
Turns on the heater for faster drying. This cycle may extend the time to your wash cycle up to 64 minutes. This
On
option is not available with the
Rinse
cycle.
1
2
3
4
5
Features and appearance will vary throughout this manual
